The Conveyor Disc 10002.03.0.08 is a standard disc for the Impact Powder Feeder. This Conveyor Disc is recommended for a variety of powders, but especially for powders with poor flowability. Replacing the Conveyor Disc is quick and easy.
In order to influence the powder feed rate, the following factors must be considered:
• Type and volume of Conveyor Disc (number and design of holes)
• Rotating speed of the Conveyor Disc
• Flowability and apparent density of the powder
- The most important key facts
- Flexible operating range
- 120 holes
- Volume: 2,968 cm³
The Conveyor Disc 10002.03.0.09 is an optional disc for the Impact Powder Feeder. The use of this Conveyor Disc is recommended when low and precise powder feed rates are required. Replacing the Conveyor Disc is quick and easy.
In order to influence the powder feed rate, the following factors must be considered:
• Type and volume of Conveyor Disc (number and design of holes)
• Rotating speed of the Conveyor Disc
• Flowability and apparent density of the powder
- The most important key facts
- Quick and easy replacement
- Ideal for low and precise powder feed rates
- 240 holes
- Volume: 1,424 cm³
The Conveyor Disc 10002.03.0.10 is an optional disc for the Impact Powder Feeder. This Conveyor Disc is recommended when using powders with good flowability. Due to the design of the Conveyor Disc, the powder feed rate is more homogeneous and the deposited coating is very uniform.
Replacing the Conveyor Disc is quick and easy.
In order to influence the powder feed rate, the following factors must be considered:
• Type and volume of Conveyor Disc (number and design of holes)
• Rotating speed of the Conveyor Disc
• Flowability and apparent density of the powder
- The most important key facts
- Quick and easy replacement
- Ideal for powders with good flowability
- Homogeneous feed rate and uniform coating
- 492 holes
- Volume: 3,043 cm³